- - -
Suppose you have a shaft that's exactly 1.000000" in diameter.
And suppose further that you have a hub with a bore of exactly 1.000000" diameter.
Is the shaft a slip fit or an interference fit in the hub's bore?
Saturday, September 25, 2010
A Riddle
At the risk of appearing a bit dense, I pose this question in all seriousness. The answer is not readily obvious to me.
Suppose you have a shaft that's exactly 1.000000" in diameter.
And suppose further that you have a hub with a bore of exactly 1.000000" diameter.
Is the shaft a slip fit or an interference fit in the hub's bore?
Suppose you have a shaft that's exactly 1.000000" in diameter.
And suppose further that you have a hub with a bore of exactly 1.000000" diameter.
Is the shaft a slip fit or an interference fit in the hub's bore?
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment